Television has grow to be so pervasive within our life that it may be tough to go even 1 day time with out viewing some type of it. whether or not it is for news, sports, or just daily entertainment, it appears practically everybody has a minimum amount of 1 television. Televisions have even produced their way outdoors and so are now readily available in designs much more durable in harsher environments.
Durablity
Along with better resistance to water, waterproof and weatherproof TVs have a much higher tolerance to things like humidity and sun damage than standard televisions. The parts that they use are of higher quality and the seals around all openings are much more secure. This makes sure that no water gets in, sometimes even while submerged.
Versatility
Owning a waterproof or weatherproof television gives you more options for placing the television than you would have with a traditional TV. They are commonly used in bathrooms, where the fog-resistant and splash-proof properties of the television help to prevent damage. They are also found in kitchens, as they prevent damage from accidents like accidental splashing.
Cost savings
Companies and individuals who are hard on their televisions can benefit from choosing waterproof tv and weatherproof over traditional televisions. Although they cost a little more upfront, the added protection means lower replacement costs in the future and therefore more savings for the company or individual in the long run.
How to Waterproof a Cable TV Connector
The best way, by far, to waterproof a cable TV connector is to make sure that your cable wire is run continuously from outside to indoors, with no breaks or connectors used. However, when there are breaks outside, it can mess up your signal to the point where it might not work at all. However there are steps you can take to protect your connectors.
1
Disconnect the wire and thread it through the PVC pipe. Reconnect the wire.
2
Caulk the ends of the wire at the points where they connect. Ensure that the entire connector is covered in caulk. Allow to dry.
3
Wrap the connector in a sandwich bag, then tape down the ends using the electrical tape. Wrap the tape around the bag until no part of the bag remains visible.
4
Pull the wire through the PVC pipe until the connector is roughly in the middle of the pipe.
5
Caulk the ends of the pipe until the ends are sealed. Be generous with the caulk; allow it to flood down into the pipe slightly. Allow it to dry.
没有评论:
发表评论